MultiNav Pro+ BLE - latency characteristics at long range, anyone measured?
Been working on a remote sensing application where I'm pushing telemetry over the BLE link at somewhere around 30-40km and I'm trying to get a realistic picture
Real questions, builds, and discussions from RFOXiA developers & makers.
💬 Want to join this discussion?
Join the Community on RFOXiA Club →Been working on a remote sensing application where I'm pushing telemetry over the BLE link at somewhere around 30-40km and I'm trying to get a realistic picture
Hey everyone, been working with the MultiNav Pro+ BLE module for a few weeks now and overall pretty impressed with the range. Running a test setup across a clea
Been messing around with the MultiNav Pro+ BLE module for a point-to-point telemetry link and I'm trying to nail down whether passive vs active scanning on the
So I've been running the MultiNav Pro+ BLE module at 2Mbps on a custom board with an STM32L4 as the host, and I'm running into what I think is a UART RX buffer
Been working on a remote sensor deployment where the BLE node is sitting out at roughly 30-35km from the central, and overall the link has been impressively sta
Hey all, been working on a telemetry system where I'm pushing status packets from a remote node out to about 40-45km and I'm trying to get a handle on what actu
Hey all, working on a wildlife monitoring setup where I want to deploy a bunch of remote sensor nodes and have a single base station that just passively listens
So I've been using the MultiNav Pro+ BLE module in a project where the remote node is sitting a few kilometers out, and I'm trying to use RSSI as a rough proxim
Hey everyone, been running some field tests with the MultiNav Pro+ BLE module out at around 30-35km line of sight and overall really impressed, but I'm running
Working on a remote telemetry setup where the BLE module is sitting out at roughly 30-35km from the base station. Everything connects fine on initial pairing an
Been working on a remote telemetry setup where I'm pushing sensor data from a field node back to a base station over the BLE link. Range isn't really the issue
Been running a point-to-point link with the MultiNav Pro+ BLE module over a rural field test, roughly 30km line of sight, and overall pretty impressed with how
Been working on a project where I need rough distance estimation between two nodes - nothing super precise, just want to know if I'm in the "close" zone vs "far
So I'm deploying a handful of these BLE modules across a mid-sized city for a remote sensor network - think rooftop-to-rooftop links ranging from maybe 2km up t
Been working on a remote sensor deployment where I need to push small telemetry packets back to a base station a few dozen km out. The BLE module has been solid
Hey all, working on a point-to-point telemetry link for a fixed outdoor installation - think one node on a rooftop and the other at a remote sensor station mayb
Been running some field tests with the MultiNav Pro+ BLE module trying to push it toward the 50km spec and I keep wondering what the actual receiver sensitivity
Hey all, been working with the BLE module for a few weeks now on a remote sensor network project and I have a question about the TX power configuration. I know
So I'm running the MultiNav Pro+ BLE and GNSS modules together on the same custom carrier board, pretty close to each other physically - maybe 15mm between them
Been planning a point-to-point link across a fairly flat rural area, roughly 45-48km between two fixed nodes. I've done plenty of sub-1km BLE stuff before but t