MultiNav Pro+ BLE - encryption overhead noticeable at long range / low SNR?
Hey all, been messing around with the BLE module for a few weeks now and overall pretty happy with it. Working on a remote sensor node deployment and security i
Real questions, builds, and discussions from RFOXiA developers & makers.
💬 Want to join this discussion?
Join the Community on RFOXiA Club →Hey all, been messing around with the BLE module for a few weeks now and overall pretty happy with it. Working on a remote sensor node deployment and security i
Been working on a remote sensor deployment where the central node is pretty far out and I'm trying to nail down the right advertising interval for the periphera
So I've got a deployment scenario where a few of these BLE modules are going to end up in pretty hard-to-reach locations - think rooftop enclosures, maybe some
Hey all, working on a remote sensor node deployment and using the MultiNav Pro+ BLE module as the main link back to a base station. Things are working, but I'm
Working on a fixed-point-to-point link using two MultiNav Pro+ BLE modules, one mounted on a static ground station and the other on a slow-moving aerial platfor
So I'm integrating the MultiNav Pro+ BLE module into a board that also has a WiFi radio running on 2.4GHz and I'm trying to figure out how bad the coexistence s
Hey everyone, working on a remote sensor node that needs to hit decent range (not full 50km, more like 5-10km in open terrain) and I'm trying to figure out how
So the spec sheet lists 50KM range and 2Mbps speed, but I'm assuming those two numbers aren't happening at the same time, right? Like the 2Mbps is presumably at
Working on a distributed sensor network where a central hub needs to maintain persistent connections to several remote nodes at once, all using the MultiNav Pro
So I'm working on a project that needs to stream low-bitrate audio (think compressed voice, not music quality) between two nodes that could be anywhere from a f
Working on a remote sensor node setup where the BLE module needs to spend most of its time in deep sleep and only wake up to push a data burst every few minutes
Been working on a tracking application where the node starts out close to the base station and then moves progressively further away. Ideally I want it running
Been running the BLE module in a long-range telemetry setup, works great so far, but I keep running into a situation where the remote node loses power unexpecte
So I'm building a tracking system for a pretty large outdoor site - think several square kilometers of open terrain - and I'm trying to figure out if it makes s
Been working on a long-range telemetry setup where the BLE module is sitting on a small UAV and streaming sensor data back to a ground station. Most of the time
Working on a deployment where the BLE module is going to be sitting pretty close to a brushless motor controller and a switching power supply - both of which ar
So I'm building a small UAV tracking system where the base station is fixed but the drone is obviously moving, sometimes pretty fast - we're talking 80-120 km/h
Been working on a long-range telemetry setup using the BLE module and one thing I can't quite figure out is how much control I actually have over which advertis
Been digging into the BLE module for a project I'm putting together - basically a network of remote sensor nodes spread across a pretty large agricultural prope
Hey everyone, John Jones from the hardware side here. We're in the middle of scoping out a deployment where we need to cover a pretty wide open area - think fla