MultiNav Pro+ BLE range in a mesh setup - any real world numbers?
So I've been messing around with the BLE module for a few weeks now and the 50km spec is obviously under ideal line-of-sight conditions, I get that. What I'm ac
Real questions, builds, and discussions from RFOXiA developers & makers.
💬 Want to join this discussion?
Join the Community on RFOXiA Club →So I've been messing around with the BLE module for a few weeks now and the 50km spec is obviously under ideal line-of-sight conditions, I get that. What I'm ac
Working on a trail monitoring project and I'm planning to use the MultiNav Pro+ GNSS module to log position data along forested hiking paths. The 1.5m accuracy
Hey all, been working on a remote wildlife monitoring node that needs to survive intermittent solar input, so the super-capacitance system in the Power/Program
So the spec sheet says "first fix in 1 sec" for the MultiNav Pro+ GNSS module and I've been trying to figure out if that's a cold start number or if it assumes
Hey all, working on an outdoor asset tracking build that's going to be mounted on some farm equipment - so it'll be sitting outside through some pretty rough te
Hey all, working on a tracker build where I want to run both the GNSS module and the sensors module at the same time off the same MCU (ESP32-S3 in my case). My
Hey all, working on a small fleet tracking setup where I've got maybe 8-10 remote nodes that all need to report back to a single base station. I'm planning to u
Hey all, working on a data logging project where I'm mounting the sensors module to a slow-moving platform (basically a motorized camera rig) and letting it run
So I've been integrating the MultiNav Pro+ sensors module into a small environmental monitoring node and I'm starting to wonder about thermal self-heating skewi
Hey everyone, been working on a tracking/orientation build using the sensors module alongside the GNSS and BLE modules all stacked fairly close together. Everyt
Been working on a deployment where the BLE module needs to live inside a sealed ABS enclosure - roughly 3mm wall thickness, nothing crazy. I know the 50km range
Hey all, working on an asset tracking build that needs to perform reasonably well across different regions - US, EU, and eventually some parts of Southeast Asia
Hey all, working on a asset tracking build and finally pulled the trigger on the Power/Program Kit to go with my MultiNav Pro+ stack. Got everything wired up an
Been working on a remote sensor node setup where the BLE module spends most of its time in a low-power sleep state and only wakes up to push data every few minu
Been digging into the BLE module specs and the 2Mbps data rate caught my eye. I get that BLE 5.x supports 2M PHY but in my experience most implementations silen
Hey all, working on a project where I need two remote nodes to communicate with each other without routing through a central device or gateway. Basically a peer
Been playing around with the MultiNav Pro+ BLE module for a project I'm building - basically a low-bandwidth telemetry link between a base station and some remo
Hey all, working on an outdoor environmental monitoring node and I picked up the sensors module partly because of the air quality sensor listed in the specs. My
Been working on a trail mapping project where the routes go pretty deep into forested areas - like thick Pacific Northwest canopy type stuff. I'm using the Mult
Working on a trail mapping project and I've been really happy with the GNSS module so far in open sky conditions, hitting close to the advertised 1.5m pretty co