MultiNav Pro+ sensors - humidity sensor response time during rapid env changes?
Working on a weather balloon payload project and I'm using the MultiNav Pro+ sensors module alongside the GNSS module to log environmental data during ascent. E
Real questions, builds, and discussions from RFOXiA developers & makers.
💬 Want to join this discussion?
Join the Community on RFOXiA Club →Working on a weather balloon payload project and I'm using the MultiNav Pro+ sensors module alongside the GNSS module to log environmental data during ascent. E
So I'm building a remote telemetry setup where the base station is pretty far from the sensor nodes - we're talking potentially 1-2km in a semi-open field envir
Hey all, been working on a field deployment unit where the MultiNav Pro+ is going to be running pretty much continuously off solar with a small panel feeding in
So I've been using the MultiNav Pro+ BLE module for a few weeks now and overall pretty happy with it, but I want to dig into this 50km range spec a bit more. I
Been integrating the MultiNav Pro+ GNSS module into a small autonomous ground vehicle and I'm trying to figure out if the 18Hz fix rate applies to the full NMEA
So I'm running the GNSS module and the sensors module together on a mobile tracking build and I've been thinking about whether it makes sense to fuse the accele
Been working on a UAV nav stack and I'm trying to figure out if the 18Hz fix rate on the GNSS module is clean enough to pipe directly into a Kalman filter along
Hey everyone, working on a data logging build with the MultiNav Pro+ GNSS module and I'm trying to figure out the best way to handle the 18Hz output without dro
Hey everyone, been integrating the Power/Program Kit into a custom enclosure for a field data logger and ran into something I want to make sure I understand bef
So I've been working with the sensors module for a few weeks now and overall pretty happy with it. The accelerometer, baro, and humidity stuff all make sense to
So I've got both the MultiNav Pro+ BLE module and the GNSS module running on the same custom carrier board and I'm starting to wonder if they're stepping on eac
Hey everyone, working on a tracker build where I'm mounting the MultiNav Pro+ sensors module inside a metal enclosure (aluminum, not steel, if that matters). I
Been running the MultiNav Pro+ GNSS module for a few weeks now on a UAV tracking build and overall pretty impressed with the fix times and accuracy out in open
So I'm building a remote monitoring node that'll be deployed somewhere pretty inaccessible, and naturally I want OTA firmware updates so I don't have to physica
Hey all, been running the MultiNav Pro+ GNSS module in a few different environments and it's been solid out in open areas, hitting that ~1.5m accuracy pretty co
So I've been running the GNSS module in a UAV application where I actually need that full 18Hz fix rate to stay consistent - not just burst to it occasionally.
Been running the GNSS module on a field mapping project for a few weeks now and overall pretty happy with it, but I've been noticing some inconsistency in how f
Been working with the sensors module for a few weeks now and I'm getting temperature readings that seem consistently higher than ambient - like 3 to 5°C above w
Hey all, working on a remote sensor node that'll go through power cycles pretty regularly - think solar topped off during the day but fully draining overnight i
So the spec sheet says "First Fix in 1 sec" and I've been trying to figure out if that's a cold start number or if there's an asterisk buried somewhere I'm miss