MultiNav Pro+ BLE - what protocol stack is it running under the hood?
Been digging into the MultiNav Pro+ BLE module for a project that needs a pretty custom connection scheme - basically a star topology with one coordinator and a
Real questions, builds, and discussions from RFOXiA developers & makers.
💬 Want to join this discussion?
Join the Community on RFOXiA Club →Been digging into the MultiNav Pro+ BLE module for a project that needs a pretty custom connection scheme - basically a star topology with one coordinator and a
Been integrating the BLE module into a asset tracking build and something's been bugging me. At 50km range the thing is obviously pushing some serious RF power
So I'm putting together a UAV telemetry setup using the GNSS module and the sensors module together, and I keep running into this question I can't fully answer
Hey all, working on a project where I need to dynamically switch between throughput and range depending on the situation - basically short-range high-speed data
So I've been planning a deployment where I need to cover a pretty wide agricultural area - think flat farmland with a few structures scattered around, grain sil
So I'm deep into planning a long-range telemetry setup using the MultiNav Pro+ BLE module and I keep hitting this question that I can't find a clear answer to i
Been digging into the MultiNav Pro+ BLE module specs and the 50km range figure is obviously the headline grabber. I get that long-range BLE with a solid RF fron
So I've been testing the BLE module for a drone tracking project and most of the range benchmarks I've seen online are done with both endpoints sitting complete
Hey all, been working on a wildlife tracking build where I'm running the BLE module and the GNSS module together, and I've hit kind of an annoying edge case I c
Been working on integrating the MultiNav Pro+ BLE module into a custom PCB and I'm trying to figure out how much of the RF front-end is handled internally vs wh
Hey all, working on a tracker build and I'm planning to stack the GNSS module, the sensors module, and the BLE module together powered off the MultiNav Pro+ Pow
So I'm working on a tracking project where I need rough distance estimates between a base node and a few remote units, and I'm planning to use the MultiNav Pro+
So I've been looking at the MultiNav Pro+ BLE module for a long range telemetry project and the 50km spec is obviously the headline feature. I'm not doubting it
So I'm putting together a tracking setup where I've got two nodes, both mobile - one on a ground vehicle and one on a drone. Neither end is stationary. I know t
Hey all, picking up the sensors module for an outdoor environmental monitoring node I'm building and I'm trying to figure out exactly what the air quality senso
Been working on a mobile tracking build where I'm pulling GNSS fixes at 18Hz and streaming the position data out over BLE basically continuously. Works great on
Been digging into the MultiNav Pro+ GNSS module specs and the 1.5m accuracy figure is what caught my attention initially. I'm building a UAV tracking/logging sy
Hey everyone, James here. We're building a small fleet tracking device around the MultiNav Pro+ GNSS module and the 1-second first fix spec is honestly one of t
Hey all, working on a small autonomous ground vehicle project and I'm trying to figure out if I can rely on the MultiNav Pro+ GNSS module for heading data purel
Been digging into the GNSS module specs and the 18Hz fix rate is what caught my eye. Most of the modules I've worked with top out at 10Hz in continuous mode and