MultiNav Pro+ BLE - multiple simultaneous connections, is it doable?
Working on a small mesh-ish setup where I've got a central node that needs to maintain connections to maybe 4-6 peripheral devices at the same time, all running
Real questions, builds, and discussions from RFOXiA developers & makers.
💬 Want to join this discussion?
Join the Community on RFOXiA Club →Working on a small mesh-ish setup where I've got a central node that needs to maintain connections to maybe 4-6 peripheral devices at the same time, all running
Been running the sensors module on a fixed ground station setup for a few days now - no movement, just sitting there logging. Noticed the gyro output slowly cre
Hey all, working on a project where I'm mounting the MultiNav Pro+ BLE module on a vehicle (think slow-moving agricultural equipment, not a race car) and stream
Been working on a UAV logging build using the sensors module alongside the GNSS module and ran into something I wasn't expecting. The air pressure sensor is giv
So I'm building a rover that needs reliable heading data even when it's sitting still or moving really slowly (under like 0.3 m/s), which is where GNSS course-o
Been integrating the Power/Program Kit into a remote telemetry node and I'm trying to wrap my head around how the super-capacitance battery system actually beha
Hey everyone, working on a long-range telemetry setup with the MultiNav Pro+ BLE module and I'm running into what I think is an antenna placement issue but I wa
Been working with the MultiNav Pro+ BLE module for a couple weeks now and honestly the range has been impressive so far, but I'm trying to understand how TX pow
Been integrating the MultiNav Pro+ GNSS module into a forestry survey tool and running into some inconsistency I wasn't fully expecting. In open sky the 1.5m ac
Hey everyone, been setting up my MultiNav Pro+ stack for a remote asset tracking build and I'm running into something a bit confusing with the Power/Program Kit
Hey all, been working with the MultiNav Pro+ setup for a few weeks now and overall pretty happy with it, but I've hit a workflow snag I'm trying to figure out.
Hey all, been working with the GNSS module for about two weeks now and overall pretty impressed with the 1.5m accuracy once it settles. But I'm running into som
So I'm building a asset tracking device that'll run mostly off the Power Kit's super-cap system, and I'm trying to figure out if there's a meaningful tradeoff b
So I've been running the sensors module on a outdoor weather station build for about 3 weeks now and I'm starting to notice the magnetometer heading is slowly d
So I've got the GNSS module pushing fixes at 18Hz and I'm trying to stream that data in real-time over the BLE module to a base station. On paper the 2Mbps BLE
Been digging into the BLE module specs and I'm a bit confused about how the 2Mbps PHY interacts with the long range side of things. My understanding is that BLE
So the spec sheet says "first fix in 1 second" and I've been trying to figure out if that's a hot start number or if they actually mean cold start too. I'm buil
Hey everyone, been integrating the MultiNav Pro+ BLE module into a remote sensor node that's going to be running off the Power Kit's supercap system, and I'm tr
Hey all, been working with the sensors module for a few weeks now and overall pretty happy with it, but I'm kinda stuck on the air quality side of things. The s
So I'm building a data logging setup where I want to pair the BLE module with the sensors module and stream everything - IMU, temp, pressure, the works - over B